Winegard SKA-733 Manuale Utente Scaricare il pdf

Notches in

skew plate

FIGURE 1. Anchor posts and notches to align

Anchor posts

in reflector

FIGURE 2. Installing reflector, LNBF, and feed arm. A, Reflector held on skew plate with clamps. B, Coax cables connected. C, P-clamp on lift arm.

CBA

Installing the Reflector, LNBF, & Feed Arm

Note that the reflector, LNBF, and feed arm are packaged separately as SKA-733.

1. Press and hold “POWER” for two seconds to turn on the interface box. Wait until the interface box finishes

“connecting to antenna.” The TRAV’LER

antenna may enter the search routine after ten seconds. Pay attention to

the pinch points as the antenna raises!

2. Wait until the antenna has at least raised to a position in which the lift arms are perpendicular to the roof. Then, press

“POWER” and “SELECT” at the same time. The antenna should stop moving.

3. Unplug the interface box.

4. Insert the two longer screws into the top two holes in the front of the reflector.

5. Slide a wedge-shaped clamp onto each screw sticking out the back of the reflector.

6. Thread a nut onto each screw; make sure the nut is tight to keep the clamp from falling.

7. Align the two anchor posts on the back of

the reflector with the two notches in the skew

plate (see fig. 1). Then, set the reflector on the

skew plate; the reflector should be positioned

with the LNB arm at the bottom of the plate.

Carefully use the clamps on the back of the

reflector to hold the reflector in place (see

fig. 2A); make sure that the thicker part of the

clamp is to the outside of the reflector.

8. Once the top screws and clamps are in place, install the lower screws and clamps.

9. With the bracket mounted securely, connect the four coax cables to the mount (see fig. 2B).

10. Locate the cable tie on the coax cables that you just connected to the mount. Place the p-clamp on the cables so that

it is just below this cable tie. If the cable tie is missing, install the clamp 14” from the end of the connectors.

11. Carefully screw this clamp to the front of the lift arm using the provided

” screw (see fig. 2C). Warning: Be careful

not to strip out the hole for the

” screw when you replace the clamp holding the coax cables to the arm. Do not

use a power tool. Do not overtighten this screw.

12. Plug in the interface box.

13. Press and hold “POWER” for two seconds to turn on the interface box. Press the Power button again to stow the antenna.

2452259

1 2

WS-MOBWARREV2 2
Rev. 1/10 2

Sommario

Pagina 1

Notches in skew plateFIGURE 1. Anchor posts and notches to alignAnchor posts in reflectorFIGURE 2. Installing reflector, LNBF, and feed arm. A, Refl

Pagina 2 - Rev. 1/10

Commenti su questo manuale

Nessun commento

Winegard SKA-733 Manuale Utente

Navigare online o scaricare Manuale Utente per Supporti Winegard SKA-733. Winegard SKA-733 User's Manual Manuale Utente

Sommario

Commenti su questo manuale